| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN THE KEY TO TURN MACHINE OFF. PULL THE CHARGER PLUG TO DISCONNECT THE BATTERIES. PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 2 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 3 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE. LIFT THE TANK TO OPEN THE MACHINE.
| Wrench-Allen metric 6.0mm |
|
|
| 4 |
|
DISCONNECT THE BATTERY CABLES AND REMOVE THE 2 BATTERIES FROM THE MACHINE.
| Wrench-metric 10mm |
|
| Wrench-metric 13mm |
|
|
| 5 |
|
REMOVE THE 2 BOLTS HOLDING THE BRUSH SHROUD.
| Wrench-Allen metric 6.0mm |
|
|
| 6 |
|
LAY THE MACHINE ON ITS SIDE.
|
| 7 |
|
REMOVE THE 3 SCREWS FROM THE COVER
| Wrench-Allen metric 6.0mm |
|
|
| 8 |
|
PULL TO REMOVE THE COVER
|
| 9 |
|
WHILE TURNING THE TENSIONER BY HAND, VISUALLY INSPECT FOR ANY CRACKS. TURN THE TENSIONER TO THE RIGHT AND IT SHOULD SPRING BACK IN POSITION.
|
| 10 |
|
IF TENSIONER IS OKAY, REVERSE STEPS 4 THRU 8 TO REASSEMBLE THE MACHINE. RECONNECT THE CHARGER PLUG. RECONNECT THE BATTERY CABLES USING THE DIAGRAM SHOWN HERE.
|